Interpretation of assembly task constraints from position and force sensory data

Document Type

Conference Proceeding

Publication Date

3-1-1990

Abstract

One of the major deficiencies in current robot control schemes is the lack of high-level knowledge in the feedback loop. Typically, the sensory data acquired are fed back to the robot controller with minimal amount of processing. However, by accumulating useful sensory data and processing them intelligently, one can obtain invaluable information about the state of the task being performed by the robot. This paper presents a method based on the screw theory for interpreting the position and force sensory data into high-level assembly task constraints. The position data are obtained from the joint angle encoders of the manipulator and the force data are obtained from a wrist force sensor attached to the mounting plate of the manipulator end-effector. The interpretation of the sensory data is divided into two subproblems: representation problem and interpretation problem. Spatial and physical constraints based on the screw axis and force axis of the manipulator are used to represent the high-level task constraints. Algorithms which yield least-squared error results are developed to obtain the spatial and physical constraints from the position and force data. The spatial and physical constraints obtained from the sensory data are then compared with the desired spatial and physical constraints to interpret the state of the assembly task. Computer simulation and experimental results for verifying the validity of the algorithms are also presented and discussed. © 1990 SPIE.

Identifier

84958489698 (Scopus)

Publication Title

Proceedings of SPIE the International Society for Optical Engineering

External Full Text Location

https://doi.org/10.1117/12.969800

e-ISSN

1996756X

ISSN

0277786X

First Page

2

Last Page

13

Volume

1193

This document is currently not available here.

Share

COinS