Cervical spine strength after facet injury and spine plate application

Document Type

Article

Publication Date

1-1-1991

Abstract

Although metallic plates are used for cervical spine stabilization, few biomechanical studies have been dons to evaluate their efficiency. A previous study indicated that one half of the facet joint may be destroyed before compromise in strength occurs. Isolated motion segments in which one half of the facet joint was resected bilaterally were used. A two-hole Roy-Camille plate was attached bilaterally with 3.5-mm-diameter, 16-mm-long screws and the construct loaded in shear. Failure occurred at 415.6 N by fracture through the screw holes of the damaged joint, compared to a failure load of 699.6 N in specimens without screws and plates but in which 75% of the joint had been destroyed. Results were significant at the 95% confidence level. A second group of specimens using C2—3—4 and C5—6—7 was tested after 50% facet resection and application of a three-segment plate. Failure again occurred by fracture through the screw hole at the damaged joint. We conclude that, if significant facet destruction is present, screw holes for plate application further weakens the bone. The desired biomechanical stability may not be present. © Lippincott-Raven Publishers.

Identifier

0026043537 (Scopus)

Publication Title

Spine

External Full Text Location

https://doi.org/10.1097/00007632-199110001-00021

e-ISSN

15281159

ISSN

03622436

PubMed ID

1801272

First Page

S558

Last Page

S560

Volume

16

This document is currently not available here.

Share

COinS